Dell PowerEdge T610 Hardware Owner's Manual - Page 164

9 Check the memory channels and ensure that they are populated correctly. See "General Memory Module Installation Guidelines." 10 Reseat the memory modules in their sockets. See "Installing Memory Modules." 11 Replace the cooling shroud. See "Installing the Cooling Shroud." 12 Replace the expansion card stabilizer. See "Installing the Expansion Card Stabilizer." 13 Close the system. See "Closing the System." 14 Place the system upright and on its feet on a flat and stable surface, reconnect the system to the electrical outlet, and turn on the system and attached peripherals. 15 As the system boots, observe any error messages or LCD messages that appear. 16 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen." If the problem is not resolved, proceed with the next step. 17 Turn off the system and attached peripherals, and disconnect the system from the power source. 18 Open the system. See "Opening the System." 19 Remove the expansion card stabilizer. See "Removing the Expansion Card Stabilizer." 20 Remove the cooling shroud. See "Removing the Cooling Shroud." 21 If a diagnostic test or error message indicated a specific memory module as faulty, swap or replace the module. 22 To troubleshoot an unspecified faulty memory module, replace the memory module in the first memory-module socket with a module of the same type and capacity. See "Installing Memory Modules." 23 Replace the cooling shroud. See "Installing the Cooling Shroud." 24 Replace the expansion card stabilizer. See "Installing the Expansion Card Stabilizer." 25 Close the system. See "Closing the System." 164 Troubleshooting Your System