HP C8180 Windows Help - Page 50
Wireless 802.11 network settings - and mac
UPC - 883585123384
View all HP C8180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Finish setup Wireless (802.11) network settings The following table describes the 802.11 wireless settings shown on the network configuration page. Parameter Hardware Address (MAC) Description The Media Access Control (MAC) address that identifies the HP All-in-One. This is a unique 12-digit identification number assigned to networking hardware for identification, including wireless access points, routers, and other such devices. No two pieces of hardware have the same MAC address. Two MAC addresses are assigned: one for wired Ethernet and one for wireless 802.11. NOTE: Some Internet service providers (ISPs) require that you register the MAC address of the Network Card or LAN Adapter that was connected to your cable or DSL modem during installation. IP Address This address uniquely identifies the device on the network. IP addresses are assigned dynamically through DHCP or AutoIP. You can also set up a static IP address, though this is not recommended. NOTE: Manually assigning an invalid IP address during installation will prevent your network components from seeing the HP All-in-One. Subnet Mask A subnet is an IP address assigned by the installation software to make an additional network available as part of a larger network. Subnets are specified by a subnet mask. This mask determines which of the HP All-in-One IP address bits identify the network and subnet, and which bits identify the device itself. NOTE: It is recommended that the HP All-in-One and the computers that use it all reside on the same subnet. Default Gateway A node on a network that serves as an entrance to another network. A node in this instance can be a computer or some other device. NOTE: The address of the default gateway is assigned by the installation software. Configuration Source DNS server The protocol used to assign the IP address to the HP All-in-One: • AutoIP: The installation software automatically determines the configuration parameters. • DHCP: The configuration parameters are supplied by a dynamic host configuration protocol (DHCP) server on the network. On small networks, this could be a router. • Manual: The configuration parameters are set manually, such as a static IP address. • Not Specified: The mode used when the HP All-in-One is initializing. The IP address of the domain name service (DNS) for the network. When you use the Web or send an e-mail message, you use a domain name to do it. For example, the URL http://www.hp.com contains the domain name hp.com. The DNS on the Internet translates the domain name into an IP address. Devices use the IP addresses to refer to one another. • IP Address: The IP address of the domain name server. • Not Specified: The IP address is not specified, or the device is initializing. Connect to a network 49