HP ML370 HP ProLiant ML370 Generation 3 Setup and Installation Guide - Page 46

3 Installing Hardware Options This chapter provides information and procedures for installing hardware options in a ProLiant ML370 Generation 3 server. For more information, refer to the installation documentation that ships with each option kit. To streamline the installation process if you are installing more than one option, read the installation instructions for all of the hardware options and identify similar steps before installing each component. After you install hardware options, proceed with the server installation procedures in Chapter 4, "Installing the Rack Server," or Chapter 5, "Installing the Tower Server." For additional information about installation or troubleshooting procedures, refer to the Documentation CD that ships with the server or contact your authorized reseller. WARNING: To reduce the risk of personal injury or damage to the equipment: • Heed all warnings and cautions throughout the installation instructions. • Allow internal system components to cool before touching any surfaces. • Be sure that the power to the server is turned off and that the AC power cord is disconnected before removing the access panel. CAUTION: Always be sure that equipment is properly grounded before beginning any installation procedure. Electrostatic discharge resulting from improper grounding can damage electronic components. For more information, refer to Appendix B, "Electrostatic Discharge." HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-1