HP ML370 HP ProLiant ML370 Generation 3 Setup and Installation Guide - Page 68
Remove the access panel. Refer to Removing the Access Panel in
UPC - 613326765616
View all HP ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Installing Hardware Options CAUTION: Always install a PPM when you install a processor. The system fails to boot if the processor or PPM are missing. IMPORTANT: When you install a second processor and PPM, the processor must be the same type and speed as the primary processor. Install only the PPM provided in the option kit with the processor. NOTE: The appearance of compatible PPMs may vary. Observe the warnings and cautions provided in the option kit documentation and in this guide. To install the processor assembly: 1. Power down the server. Refer to "Powering Down the Server" in this chapter. 2. Remove the access panel. Refer to "Removing the Access Panel" in this chapter. 3. Remove the processor air baffle: a. Loosen the two thumbscrews that secure the air baffle to the system tray (1). b. Lift the air baffle up and out of the server (2). Figure 3-18: Removing the processor air baffle HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-23