HP ML370 HP ProLiant ML370 Generation 3 Setup and Installation Guide - Page 99
Drive, in this documentation that ships with the hard drive.
UPC - 613326765616
View all HP ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Installing Hardware Options 4. Remove the Torx T-15 screws from the bezel blank and attach them to the tape drive as described in steps 4 and 5 in "Installing a Non-Hot-Plug SCSI Hard Drive," in this chapter. Figure 3-43: Attaching installation screws to a tape drive IMPORTANT: Each SCSI device in the server must have a unique address. The server automatically sets all SCSI IDs for hot-plug drives, but you must set the SCSI IDs for devices installed in the media cage. 5. Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the documentation that ships with the hard drive. 3-54 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
Installing Hardware Options
3-54
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
4.
Remove the Torx T-15 screws from the bezel blank and attach them to the tape
drive as described in steps 4 and 5 in “Installing a Non-Hot-Plug SCSI Hard
Drive,” in this chapter.
Figure 3-43:
Attaching installation screws to a tape
drive
IMPORTANT:
Each SCSI device in the server must have a unique address. The server
automatically sets all SCSI IDs for hot-plug drives, but you must set the SCSI IDs for
devices installed in the media cage.
5.
Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the
documentation that ships with the hard drive.