HP ML370 HP ProLiant ML370 Generation 3 Setup and Installation Guide - Page 94
Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the, screws from the bezel blanks.
UPC - 613326765616
View all HP ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Installing Hardware Options 4. Use the Torx T-15 tool provided with the server to remove the four installation screws from the bezel blanks. Figure 3-39: Removing installation screws from a bezel blank IMPORTANT: Each SCSI device in the server must have a unique address. The server automatically sets all SCSI IDs for hot-plug drives, but you must set the SCSI IDs for devices installed in the media cage. 5. Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the documentation that ships with the hard drive. HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-49
Installing Hardware Options
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
3-49
4.
Use the Torx T-15 tool provided with the server to remove the four installation
screws from the bezel blanks.
Figure 3-39:
Removing installation screws from a bezel
blank
IMPORTANT:
Each SCSI device in the server must have a unique address. The server
automatically sets all SCSI IDs for hot-plug drives, but you must set the SCSI IDs for
devices installed in the media cage.
5.
Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the
documentation that ships with the hard drive.