Lexmark M410 User's Guide - Page 189

Problem (continued) Action (continued) Print material misfeeds or multiple feeds occur. • Make sure the print material you are using meets the specifications for your printer. See "Print Material Guidelines" on page 118 for more information. • Flex print material before loading it in any of the paper sources. • Make sure the print material is loaded correctly. • Make sure the paper width and length guides on the paper sources are adjusted correctly and are not too tight. • Do not overfill the paper sources. • Do not force print material into the multipurpose feeder when you load it; otherwise, it may skew or buckle. • Remove any curled print material from paper sources. • If there is a recommended print side for the print material, load the print material as described in "Print Material Guidelines" on page 118. • Load less print material in the input sources. • Turn the print material over or around and try printing again to see if feeding improves. • Do not mix print material types. • Do not mix reams of print material. • Remove the top and bottom sheets of a ream before loading the print material. • Load an input source only when it is empty. You get unexpected page breaks. Check the Print Timeout setting in the SETUP MENU. Increase the setting. See Print Timeout on page 74 for more information. Job prints from the wrong input source or on the wrong print material. Check the PAPER TYPE setting in the PAPER MENU on the operator panel and in the printer driver. See PAPER TYPE on page 47 for more information. Print material does not stack neatly in an output bin. • Turn the print material stack over in the tray or multipurpose feeder. • If the print material is exiting to the standard output bin, make sure the paper bail is installed correctly. See "Installing the Paper Bail" on page 11 for more information. Printing Problems 177