Lexmark M410 User's Guide - Page 87

Setup Menu (continued) Menu Item Auto Continue Values Disabled* 5...255 Jam Recovery Set Auto Continue to a value between 5 seconds and 255 seconds to have the printer continue printing after it detects one of the following errors: 34 Short Paper 35 Res Save Off Deficient Memory 37 Insufficient Collation Area 37 Insufficient Defrag Memory 37 Insufficient Memory 38 Memory Full 39 Complex Page 51 Defective Flash 52 Flash Full 53 Unformatted Flash 54 Serial Option 1 Error 54 Std Par ENA Connection Lost 54 Par 1 ENA Connection Lost 54 Ser 1 Fax Connection Lost 54 Network 1 Software Error 55 Insufficient Fax Buffer 56 Serial Port 1 Disabled 56 Std Parallel Port Disabled 56 Parallel Port 1 Disabled 58 Too Many Flash Options 61 Defective Disk 62 Disk Full 63 Unformatted Disk Print Jobs on Disk? Go/Stop? If one of these errors occurs and Auto Continue is set to Disabled, the printer stops and waits for operator intervention. When Auto Continue is set to a numerical value, the printer waits for the specified length of time and then automatically resumes processing. This setting is also used as a timer. After an inactive period in the menus, the printer automatically exits the menus and returns to the Ready state. On Off Auto* *Factory default When Jam Recovery is set to Off, the printer does not reprint a page that has jammed. When Jam Recovery is set to On, the printer keeps the image for a printed page until the printer signals that the page has successfully exited the printer. The printer reprints all jammed pages. If Jam Recovery is set to Auto, the printer keeps the image and reprints the page unless the memory required to hold the page is needed for other printer tasks. Operator Panel Menus 75