Symantec 10521148 Implementation Guide - Page 157
Stopping Network Security from the LCD, SNS7120, Stop SNS
View all Symantec 10521148 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Maintaining and administering the 7100 Series 149 Restarting, rebooting, and powering off The LCD panel may be locked. If so, you must unlock it before you can perform tasks in the LCD run menu. These procedures are described in the following sections: ■ Stopping Network Security from the LCD ■ Stopping Network Security from the serial console ■ Starting Network Security from the LCD ■ Starting Network Security from the serial console ■ Restarting Network Security from the Network Security console ■ Restarting Network Security from the serial console Stopping Network Security from the LCD This section describes the procedure for using the LCD panel to stop Symantec Network Security on the node. To stop Symantec Network Security from the LCD 1 On the appliance front panel, press any button to change the LCD display. If the LCD screen is locked, see "Unlocking the LCD panel" on page 155 to unlock it. 2 Press any button to display the LCD run menu unless it is already displayed on the LCD screen. 3 Use the down arrow button to scroll through the menu until you see: SNS7120 3. Stop SNS where 7120 is replaced by 7160 or 7161 depending on the model. 4 Press e to stop Symantec Network Security. Stopping Network Security from the serial console This section describes the procedures for using the serial console to stop the Network Security application. To stop Symantec Network Security from the serial console 1 Connect your laptop or other serial device to the appliance with the serial console cable. 2 Using a serial terminal application, login to the appliance as secadm. 3 Type the command: stop