Panasonic WJHD316A WJHD309A User Guide - Page 40
To delete the motion detection area, Detection Mode, Rotate the jog dial to select DELETE AREA
View all Panasonic WJHD316A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
G To delete the motion detection area MONITOR1 MONITOR2 R 123 4 STOP PLAY PAUSE REC - REC STOP REV FWD R PAN/ GOTO TILT LAST SEARCH SHIFT SEQ OSD PAN/TILT SETUP 567 8 ZOOM/ A-B SLOW /ESC FOCUS REPEAT - + DISK SELECT COPY TEXT MARK 9 10/0 11 12 IRIS LISTED 1 EL-ZOOM LOGOUT LOGOUT PRESET /AUTO 2 13 14 15 16 SET BUSY x zx z z Rotate the jog dial to select "DELETE AREA" on the status bar. Any motion will be detected anywhere in the A, B, C, D areas. Note: In the ANY AREA mode, it is possible to set the masking duration. When the masking duration is set, motion will be ignored for a certain period (set duration as the masking duration) in the same area. It is convenient to set the masking duration to make the subject period shorter in case it is necessary to search an 316 extended time range or when searching through many results. It will be subject to listing if an object moves within the set time to the other detection areas in the set order. The following is an example. A 10 s B 20 s C D 10 s Note: To delete all the motion detection areas, select "DELETE ALL AREA" and press the SET button. x Move the cursor to the motion detection area to be deleted using the arrows button and press the SET button. The selected area will be deleted. G Detection Mode Set how to detect motion in the set motion detection area. There are 3 detection modes as follows. Note: It is impossible to set two or more detection modes simultaneously. It will be subject to listing if "motion" is detected in any of the set motion detection areas. Motion is detected in area B within 10 seconds after being detected in area A. Motion is detected in area C within 20 seconds after being detected in area B. Motion is detected in area D within 10 seconds after being detected in area C. When all of the above have occurred, an event action will be performed. It will be subject to listing if an object keeps moving for the set period in the detection area. For example, in case of the following settings; 10 sec. for areas A and B, 20 sec. for area C and 30 sec. for area D: An event action will be performed when an object keeps moving longer than the set period in the specified detection area. 10 s 10 s A B A B C D 40 C D 20 s 30 s Important: • When images to be searched are recorded with a low recording rate, the DURATION mode may not work correctly. • It may take some time to search according to the contents of the recorded images.