Panasonic WJHD316A WJHD309A User Guide - Page 73

I Connections when the unit is used independently An example of connections is shown below when the unit is used independently. Important: • When connecting the Panasonic matrix switcher or the coaxial communication unit to this unit, the looped through output signal for every video input signal from them must be supplied to the video input connectors of this unit directly. Do not supply the monitor output signal or the spot output signal from the matrix switcher or the coaxial communication unit to the video input connectors of this unit. Otherwise, the improper image switching may occur and the images displayed before switching channels may be displayed and recorded. • The power plug should be connected last. • When connecting combination cameras, connect them to the video input connectors 1 - 8 when using the WJ-HD316A or 1 - 6 when using the WJ-HD309A (for coaxial communication). G Examples of connections Monitor 1 Microphone Amplifier Monitor 2 Mode switch setting (Factory default) ON 12345678 Note: If the DATA and RS485 ports are not used, the mode switches should be used as illustrated. 3 1 1 SERIAL ALARM 4 2 AUDIO IN AUDIO OUT CASCADE OUT 2 MONITOR OUT CASCADE IN MONITOR (VGA) ALARM/CONTROL 16 15 14 13 12 11 10 9 8 7 IN OUT 16 15 14 13 12 11 10 9 8 7 VIDEO 1 8 MODE 2 1 COPY 1 DATA 6 5 RS485(CAMERA) 10/100BASE-T EXT STORAGE 4 3 2 1 6 5 4 3 2 1 For Audio Amplifier System cameras (VIDEO IN 9 - 16) Combination cameras (VIDEO IN 1 - 8) SIGNAL GND POWER AC IN 120 V AC 60 Hz Notes: • The SETUP MENU will be displayed on monitor 2 and the VGA monitor. (It is impossible to display the SETUP MENU on monitor 1.) • The same images displayed on monitor 2 will be displayed on the VGA monitor. 73