Dell PowerConnect B-RX16 Installation Guide - Page 167
Replacing the fan assembly in the BigIron RX-4 and BigIron RX-8,
View all Dell PowerConnect B-RX16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
Replacing cooling system components 6 3. Remove the fan assembly from the chassis by grabbing the handle on the fan assembly and pulling it toward you as shown in Figure 79. Pulling the enclosure unseats the fan assembly connector from a chassis connector. DANGER Be careful not to insert your fingers into the fan while removing it from the chassis. The fan may still be spinning at a high speed. FIGURE 79 Removing a BigIron RX-16 front fan assembly 1 1 Fan assembly 4. Insert the new fan assembly into the fan slot and push the enclosure in until the face plate is flush with the chassis. Pushing the enclosure in seats the fan connector with the chassis connector. 5. Secure the fan to the chassis by tightening the four captive screws. 6. Access the CLI, and enter the show chassis command to verify that the fans are operating normally. Replacing the fan assembly in the BigIron RX-4 and BigIron RX-8 The BigIron RX-4 and BigIron RX-8 have a fan assembly accessible from the front of the chassis. The fan assembly pulls air out of the chassis. BigIron RX Installation Guide 155 53-1001811-01