Dell PowerConnect B-RX16 Installation Guide - Page 67
Connecting AC power to a BigIron RX-16 chassis,
View all Dell PowerConnect B-RX16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Installing a BigIron RX-16 switch 2 CAUTION Carefully follow the mechanical guides on each side of the power supply slot and make sure the power supply is properly inserted in the guides. Never insert the power supply upside down. 4. After the power supply is fully inserted, push the power supply front panel toward the back of the chassis. This action causes the power supply connector to latch into the backplane connector. 5. For information about connecting power to the chassis, refer to"Connecting AC power to a BigIron RX-16 chassis" below. 6. For information about powering on the system, refer to "Powering-on the power source" on page 79. Connecting AC power to a BigIron RX-16 chassis AC power is supplied through an AC power cord that is installed at the rear of the BigIron RX-16 chassis. 1. At the rear of the BigIron RX-16 chassis, locate the power receptacle where the power supplies have been installed. 2. Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply. 3. Snap the cord-retainer over the power plug to hold it in place. FIGURE 37 Connecting a power cord to the power supply in a BigIron RX-16 chassis 1 2 3 5 1 Lift handle 2 Cord retainer 3 Power cord 4 4 Ground point 5 Lift handles BigIron RX Installation Guide 55 53-1001811-01