Dell PowerConnect B-RX16 Installation Guide - Page 49
Final steps,
View all Dell PowerConnect B-RX16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Installing a BigIron RX-4 switch 2 Follow the steps given below to connect a DC power source. NOTE The layout of the LEDs on your BigIron RX-4 DC power supply may be different from what is shown in Figure 23, due to multiple vendors; but the function is the same. 1. Use a flat-blade screwdriver to remove the two screws holding the transparent cover over the power supply lugs. FIGURE 23 The BigIron RX-4 DC power supply 1 DC DC ALM IN OK 2 1 Screws holding power lugs 2 Screws holding transparent cover 2. Use a Phillips head screwdriver to remove each of the power lugs. 3. Crimp #8 AWG power supply wire into the power lugs and reconnect the power lugs to the power supply unit. FIGURE 24 Crimping the power supply wire in the lug 1 1 #8 AWG power supply wire 4. Re-attach the transparent cover over the power supply lugs that was removed in Step 1. 5. Connect the wire to your DC power source making sure to connect the -48V cable to the negative terminal on the power supply and the 0V cable to the positive terminal. Final steps Follow the steps listed below to complete the installation: • "Attaching a management station" • "Powering-on the power source" • "Verifying proper operation" BigIron RX Installation Guide 37 53-1001811-01