HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Command Referen - Page 186
ipv6 hop-limit
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 186 highlights
remains. After you delete the manually assigned address, the automatically generated link-local address takes effect. For automatic generation of an IPv6 link-local address, see the ipv6 address auto link-local command. Examples # Configure a link-local address for VLAN-interface 100. system-view [Sysname] interface vlan-interface 100 [Sysname-Vlan-interface100] ipv6 address fe80::1 link-local Related commands ipv6 address auto link-local ipv6 hop-limit Use ipv6 hop-limit to set the Hop Limit field in the IPv6 header. Use undo ipv6 hop-limit to restore the default. Syntax ipv6 hop-limit value undo ipv6 hop-limit Default The hop limit is 64. Views System view Predefined user roles network-admin Parameters Value: Specifies the number of hops, in the range of 1 to 255. Usage guidelines The hop limit determines the number of hops necessary for an IPv6 packet to reach its destination. If the device advertises the hop limit in RA messages (set with the undo ipv6 nd hop-limit unspecified command), all RA message receivers uses the value set with the ipv6 hop-limit command to fill in the Hop Limit field. Examples # Set the maximum number of hops to 100. system-view [Sysname] ipv6 hop-limit 100 Related commands ipv6 nd hop-limit unspecified 178