HP 6125XLG R2306-HP 6125XLG Blade Switch Layer 3 - IP Services Command Referen - Page 30
Table 3, Command output, Field, Description
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Router solicit: 0 Time exceed: 0 IP header bad: 0 Timestamp request: 0 Timestamp reply: 0 Information request: 0 Information reply: 0 Netmask request: 0 Netmask reply: 0 Unknown type: 0 Table 3 Command output Field current state Line protocol current state Internet Address Broadcast address The Maximum Transmit Unit input packets, bytes, multicasts output packets, bytes, multicasts TTL invalid packet number Description Current physical state of the interface: • Administrative DOWN-The interface is shut down with the shutdown command. • DOWN-The interface is administratively up but its physical state is down, which might be caused by a connection or link failure. • UP-Both the administrative and physical states of the interface are up. Current state of the link layer protocol: • DOWN-The protocol state of the interface is down (typically when no IP address is configured for the interface). • UP-The protocol state of the interface is up. • UP (spoofing)-The protocol state of the interface pretends to be up. However, no corresponding link is present, or the corresponding link is not present permanently but is established as needed. IP address of an interface followed by: • Primary-A primary IP address. • Sub-A secondary IP address. • Unnumbered-An unnumbered IP address. • DHCP-Allocated-An IP address obtained through DHCP. • BOOTP-Allocated-An IP address obtained through BOOTP. Broadcast address of the subnet attached to an interface. Maximum transmission units on the interface, in bytes. Unicast packets, bytes, and multicast packets received on an interface (statistics start at the device startup). Number of TTL-invalid packets received on the interface (statistics start at the device startup). 22