HP C3916A HP LaserJet 5, 5M, and 5N Printer - User's Guide - Page 152
Optional Tray 3 Pickup Roller
View all HP C3916A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Optional Tray 3 Pickup Roller Before you begin these steps, switch the printer off and unplug the power cord. 1 Remove both Tray 2 and Tray 3 from the printer. Caution The printer is heavy. Use two people to lift it. 2 Lift the the printer from the Tray 3 Assembly. 3 Pinch the retaining clip on the right end of the roller with your right hand while sliding the roller off the shaft with your left hand (discard the used roller). 4 Slip the new roller onto the shaft and rotate it until properly aligned. Slide the roller to the left until it clicks into place. The inset on illustration #4 shows the correct orientation of the roller. Note If the roller is not installed correctly it will make a grinding noise during printer warm up. If this happens reinstall the roller. 5 Align the printer over the pins (A) and connector (B) on the Tray 3 Assembly, and set the printer on the assembly. Replace Tray 2 and Tray 3. Plug in the power cord and switch the printer on. If there are problems, check the installation instructions that came with the Tray 3 Assembly. 8-14 Maintaining and Adjusting the Printer EN