Yamaha M7CL M7cl V3 Owner's Manual - Page 102

Operations in the Centralogic section ● Adjusting the send levels from a channel to all MIX buses / MATRIX buses In the OVERVIEW screen, you can use the TO MIX / TO MATRIX field to send signals from a channel to the MIX buses and MATRIX buses. This field includes the following items. 1 These knobs will adjust the panning between two buses that are set to stereo. (For a stereo channel, they will adjust the volume balance of the left and right channels sent to the two buses.) 2 1 TO MIX/TO MATRIX SEND LEVEL knob Adjusts the send level of the signal sent from the input channel to each MIX bus / MATRIX bus. To adjust the value, press the knob for the desired bus to select it, and operate multifunction encoders 1-8. If the send-source is an input channel, you'll need to first select the send-destination buses (MIX buses or MATRIX buses). Use the SELECTED CHANNEL VIEW screen TO MIX/TO MATRIX button (→ p. 92) to make this selection. The screen will change as follows according to the buses you select. If MIX buses are selected as the senddestination If MATRIX buses are selected as the senddestination B TO MIX SEND ON/OFF button These are on/off switches for the signal sent from the input channel to the MIX buses. These buttons are shown only when the send-source is an input channel and the send-destination is a FIXED type MIX bus. To switch the on/off status of the signal sent from the channel to VARI type MIX buses or to MATRIX buses, press the selected knob once again to open the MIX SEND / MATRIX SEND popup window (8 ch). (Alternatively, you can use the SELECTED CHANNEL VIEW screen.) ● Adjusting the send levels from all MIX channels to a MATRIX bus In the OVERVIEW screen, you can simultaneously adjust the send level of the signals sent from all MIX channels to each MATRIX bus. To do this, use the [MATRIX] key of the NAVIGATION KEYS section to assign MATRIX channels 1-8 to the Centralogic section. At this time, the OVERVIEW screen will show the FROM MIX field. This field includes the following items. 1 Press the selected knob once again, and the MIX SEND / MATRIX SEND popup window (8 ch) will appear, depending on the send-destination buses you selected. This popup window contains on/off switches for the signals sent from the channel to the corresponding buses, and lets you select the send point (PRE or POST). (For details on the popup window → p. 234). If the send-destination MIX bus or MATRIX bus is set to stereo, the left of the two adjacent knobs will operate as the TO MIX PAN or TO MATRIX PAN knob (or as the BALANCE knob if the send-source channel is stereo). TO MIIX PAN/ TO MATRIX PAN knob 102 M7CL Owner's Manual 1 FROM MIX SEND LEVEL knob For each MATRIX bus, this shows the send level of the signals sent from MIX channels 1-16. To adjust the value, press the knob to select it, and operate multifunction encoders 1-8. If you press the selected knob once again, the MATRIX SEND popup window (8 ch) will appear. In this popup window you can switch the on/off status of the signal sent from a specific MIX channel to MATRIX buses 1-8, and select the send position (PRE/POST). (Use the / buttons in the window to select MIX channels. For details on the popup window → p. 70).