Yamaha M7CL M7cl V3 Owner's Manual - Page 69
Using the Centralogic Press the TO MIX SEND LEVEL knob for
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Using the Centralogic section Here's how you can use the multifunction encoders of the Centralogic section to adjust the send level of the signals sent from eight consecutive input channels to a specific MIX bus. 1 Make sure that an output port is assigned to each MIX bus to which you want to send signals, and that your monitor system or external effect etc. is connected to the corresponding output port. For details on assigning an output port to a MIX bus refer to p. 105. For details on connecting an external device, refer to p. 46. 2 Use the navigation keys to access the OVERVIEW screen that includes the input channel you want to control. In the OVERVIEW screen, you can use the TO MIX/ TO MATRIX field to adjust the send levels to the MIX/MATRIX bus. 1 2 3 Sending the signal from an input channel to a MIX bus 3 Press the TO MIX SEND LEVEL knob for the desired send-destination MIX bus. A bold frame will appear around all TO MIX SEND LEVEL knobs for that MIX bus. Input channel operations 4 Use multifunction encoders 1-8 to adjust the send level of the signals sent from the up to eight input channels to the selected MIX bus. 5 If necessary, you can use the navigation keys to switch the input channels that are assigned to the Centralogic section, and adjust the send levels from other input channels to the selected MIX bus. HINT • If you want to monitor the signal being sent to a specific MIX bus, use the navigation keys to access the corresponding MIX channel in the Centralogic section, and press the [CUE] key for that MIX channel. 5 If you want to make detailed settings for MIX sends, press the TO MIX SEND LEVEL knob inside the bold frame once again. When you press the currently selected TO MIX SEND LEVEL knob once again, the MIX SEND popup window will appear. The window includes the following items. 12 7 8 1 TO MIX/TO MATRIX field In this field you can switch the on/off status and adjust the level of the signal sent from the input channel to the MIX buses / MATRIX buses. Use the TO MIX/TO MATRIX buttons of the SELECTED CHANNEL VIEW screen to switch the type of send destination shown in this field (→ p. 92). B TO MIX SEND LEVEL knob This screen shows the send level of the signals sent from the input channels to the MIX bus. These knobs are shown only when the send-destination MIX bus is a VARI type. To adjust the send level, press the appropriate knob to select it, and operate multifunction encoders 1-8. If the send-destination MIX bus is set to stereo, the left knob of the two adjacent knobs will operate as a PAN knob (for a ST IN channel, the BALANCE knob). If the TO MIX SEND ON/OFF button is off, the knob will be dimmed. C TO MIX SEND ON/OFF button These are on/off switches for the signal sent from the input channels to the MIX bus. These buttons are shown only when the send-destination MIX bus is a FIXED type. 3 4 5 6 1 SEND TO This indicates the number, channel name, and icon of the MIX bus that is currently selected as the send-destination for signals. B ←/→ buttons Use these buttons to switch between send-destination buses. You can switch consecutively through MIX buses 1-16 and MATRIX buses 1-8. C Channel select button This indicates the channel number, the icon selected for that channel, and the channel name. When you press this button, that channel will be selected for operations, and the corresponding [SEL] key will light. M7CL Owner's Manual 69