Yamaha M7CL M7cl V3 Owner's Manual - Page 204
In the order of the MODE field, PARAMETER 1/2 field
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Using control changes to control parameters 6 Use the buttons of the CONTROL CHANGE MODE field to select the control change transmission/reception mode. You can choose one of the following two modes for control change transmission/reception. ● NRPN mode (when the NRPN button is on) The M7CL's various mix parameters will be transmitted and received on a single MIDI channel as NRPN messages. If you select this mode, the assignments in the list will be ignored. ● TABLE mode (when the TABLE button is on) The M7CL's various mix parameters will be transmitted and received on a single MIDI channel as control change messages. HINT • The channel on which control changes are transmitted and received is specified by the MIDI SETUP page PORT/CH field (→ p. 198). 7 Use the buttons of the CONTROL CHANGE field to turn transmission and reception on/ off, and make settings for echo output. Each button has the following function. ● Tx button Switches control change transmission on/off. ● Rx button Switches control change reception on/off. ● ECHO button Selects whether incoming control changes will be echoed out from the MIDI transmit port. 8 To change the event assignment for each control number, press the corresponding event. The MIDI CONTROL CHANGE popup window will appear. In this window you can specify the event assigned to each control number. The window contains the following items. NOTE • If NRPN mode is selected as the control change transmission/reception mode, the settings in this window are ignored. HINT • For details on the events that can be assigned to control changes, refer to the appendix (→ p. 270). 9 In the order of the MODE field → PARAMETER 1 field → PARAMETER 2 field, specify the type of event you want to assign. Use the ↑/↓ buttons to select an item. Press the OK button to confirm the change and close the MIDI CONTROL CHANGE popup window. HINT • You can also press the desired event in the field to select it. • You can press a field to highlight the item you want to select, and then turn one of the multifunction encoders to select an event. 10 Assign events to other control numbers in the same way. When you operate the parameters you assigned on the M7CL, control change messages will be transmitted to external devices. Similarly, if the corresponding control change messages are sent from an external device on the appropriate channel, the parameters assigned to those control numbers will change. HINT • You can use the CLEAR ALL button to erase all assignments to control numbers. The INITIALIZE ALL button will return all control number assignments to their default state. • Assignments to control numbers are maintained as settings for the entire system, rather than for individual scenes. 1 2 1 MODE field Select the type of event. B PARAMETER 1/2 field In conjunction with the MODE field, this specifies the type of event. 204 M7CL Owner's Manual