Yamaha M7CL M7cl V3 Owner's Manual - Page 25
Yamaha M7CL Manual
![]() |
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Rear panel D C C ST IN jacks 1-4 (M7CL-38/48) These are balanced XLR-3-31 female input jacks for inputting analog audio signals from line level devices or microphones. Nominal input level is -62 dBu to +10 dBu. Male XLR plug 1 (ground) 3 (cold) 2 (hot) D LAMP connector This is a four-pin female XLR output jack that supplies power to a separately sold gooseneck lamp (such as the Yamaha LA1L). (The M7CL-32 features this connector at one location.) E E OMNI OUT jacks These are XLR-3-32 male output jacks that output analog audio signals. These are used mainly to output the signals of MIX channels or MATRIX channels. Nominal output level is +4 dBu. Female XLR plug 2 (hot) 3 (cold) 1 (ground) NOTE • Although OMNI OUT jacks have a nominal input/output level of +4 dBu (maximum level +24 dBu), an internal switch allows this to be changed to -2 dBu (maximum level +18 dBu) if necessary. (A fee will be charged for this procedure.) For details, contact to your Yamaha dealer. Panels and controls J 9 H G F 2 F 2TR OUT DIGITAL jack This is an AES/EBU (XLR-3-32 male) jack that outputs the digital audio signal of a desired channel in AES/EBU format. This is used mainly to output the signal of the STEREO/MONO channel. G REMOTE connector (M7CL-32/48) This is a D-sub 9-pin male connector for remotely controlling an external head amp device (e.g., Yamaha AD8HR) that supports a special protocol. It can also be used to transmit/receive MIDI messages to/from an external device. Refer to the pin assignment table for information on pin assignments. (→ p. 298) On the M7CL-48ES, the EtherSound connector duplicates the function of this connector. H WORD CLOCK IN/OUT connectors These are BNC connectors used to transmit/receive word clock signals to/from an external device. The WORD CLOCK IN connector is internally terminated by 75 ohms. I MIDI IN/OUT connectors These connectors are used to transmit and receive MIDI messages to and from external MIDI devices. The MIDI IN connector receives messages from an external device, and the MIDI OUT connector transmits messages from the M7CL. These are used mainly to record M7CL parameter operations or scene/library selections on an external device, or to control M7CL parameters from an external device. J NETWORK connector This RJ-45 connector allows the M7CL to be connected to a computer via an Ethernet cable (CAT5e or higher recommended). This is used mainly to control mix parameters or edit scene memories and libraries from the dedicated "M7CL V3 Editor" application program. NOTE • The DME-N Network Driver required for connection to the Ethernet connector, the Studio Manager required for starting up M7CL V3 Editor, and the M7CL V3 Editor itself can be downloaded from the following Yamaha website. http://www.yamahaproaudio.com/downloads/ M7CL Owner's Manual 25
![](/manual_guide/products/yamaha-m7cl-m7cl-v3-owners-manual-9670c06/25.png)