Yamaha M7CL M7cl V3 Owner's Manual - Page 150

Using the Recall Safe function ● If a MATRIX channel is selected With the exception of the types of button that are displayed, this is the same as for a MIX channel. These buttons correspond to the following parameters. Button name ALL ATT EQ DYNA 1 INSERT INSERT PATCH FADER CH ON OUTPUT PATCH WITH MATRIX SEND Corresponding parameters All parameters (except for WITH MATRIX SEND) Attenuator settings EQ settings Dynamics 1 settings Insert settings Insert patching Fader positions On/off status of [ON] keys Output channel patching On/off status and send level of signals sent from input channels / MIX channels / STEREO/ MONO channels to MATRIX buses NOTE • If the ALL button is on, all buttons will be turned off except for the WITH MIX SEND button located in the lower part of the SAFE PARAMETER SELECT field. • You can switch the WITH MATRIX SEND button on/off while the ALL button is left on. ● If a DCA group is selected If you press any of the [SEL] keys of the DCA groups, the parameters for DCA groups 1-8 will be shown simultaneously. As the parameters subject to Recall Safe, you can select either "ALL" or "LEVEL/ON" (fader position and on/off status of [ON] key). Recall Safe will be enabled when you make this selection. If you want all parameters of the DCA group to be subject to Recall Safe, turn on the ALL button. Unlike when a channel is selected, Recall Safe will be enabled for that DCA group the moment you turn on either the LEVEL/ ON button or the ALL button. 5 To enable Recall Safe for the selected channel, turn on the SAFE button in the SAFE PARAMETER SELECT field. (If you selected a DCA group, turn on either the LEVEL/ON button or the ALL button.) Channels or DCA groups for which Recall Safe is enabled will be highlighted in the CH RECALL SAFE field. SAFE button HINT • In the CH RECALL SAFE field, the color of the highlight will be green if the ALL button was selected in step 4, or blue if buttons other than ALL were selected. • If you press the CLEAR ALL button, Recall Safe will be defeated for all channels and DCA groups for which it is enabled (i.e., the highlighted channels and DCA groups). • You can also switch Recall Safe on/off in the SEL CH VIEW screen's RECALL SAFE field (→ p. 95). 6 To turn on Recall Safe for global parameters, turn on the buttons of the GLOBAL RECALL SAFE field. These buttons correspond to the following parameters. Button name INPUT PATCH INPUT NAME OUTPUT PATCH OUTPUT NAME RACK 1-8 Corresponding parameters Input channel patching Input channel name Output channel patching Output channel name Rack 1-8 settings 7 When you've finished making settings, press the CLOSE button to close the popup window. Then perform a Recall operation. Only the selected channel(s) (DCA group(s) and parameter(s) will be excluded from Recall operations. Channel Link (→ p. 130) and bus settings (→ p. 234) are not subject to Recall Safe; they will always be reproduced in the recalled scene. This means that if Recall Safe is enabled for one of several channels included in a link group or one of two channels set to stereo, the parameter settings of that channel may differ from those of the other channel(s). In such cases, the applicable parameter will be automatically re-linked the next time it is operated. HINT • The Recall Safe function can be used in conjunction with the Focus function (→ p. 148). Channels or parameters that are excluded from Recall operations by either Focus or Recall Safe will not be recalled. • If you perform a Recall operation while holding down a [SEL] key, the Recall Safe settings of that channel will temporarily be abled for that Recall operation. 150 M7CL Owner's Manual