Yamaha M7CL M7cl V3 Owner's Manual - Page 182
Press the TO MIX SEND LEVEL knob that, send-destination of the TO MIX/TO MATRIX
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
About the internal effects 6 To adjust the effect send level of an input channel, use the navigation keys to access the OVERVIEW screen that includes the input channel you want to control. 2 1 9 To adjust the master level of the effect send, call up the MIX channel you specified as the input-source of the rack in step 2 to the Centralogic section, and adjust the corresponding fader. Set the level as high as possible without allowing the post-effect signal to reach the overload point. HINT • The input/output levels of the effect are shown by the input/ output meters at the upper right of the EFFECT popup window. 10 To adjust the effect return level, operate the ST IN channel you selected as the outputdestination for the rack in step 3. 1 TO MIX/TO MATRIX field B TO MIX SEND LEVEL knob 7 Make sure that a MIX bus is selected as the send-destination of the TO MIX/TO MATRIX field. If a MATRIX bus is selected as the send-destination (the field indicates "TO MATRIX"), use the SELECTED CHANNEL VIEW screen's TO MIX/TO MATRIX button to switch to a MIX bus (→ p. 175). 8 Press the TO MIX SEND LEVEL knob that corresponds to the desired MIX bus, and turn the multifunction encoder to adjust the send level of the signal sent from each channel to the MIX bus. In this state you can adjust the send level of the signal sent from the input channel to the internal effect. Adjust the send level of other input channels in the same way. If you press the selected knob once again, the MIX SEND popup window (8 ch) for the send-destination MIX bus will appear. This popup window contains on/ off switches for the signals sent from each channel to the corresponding bus, and lets you select the send point (PRE or POST) (→ p. 70). NOTE • At this time, you must be sure that the send level from the ST IN channel you selected in step 3 to the corresponding MIX bus is set to 0. If you raise this send level, the output of the effect will be returned to the input of the same effect, possibly causing oscillation. 182 M7CL Owner's Manual