Yamaha M7CL M7cl V3 Owner's Manual - Page 99

About the OVERVIEW screen E EQ field This is a graph that shows the approximate EQ response for each channel. F DYNAMICS 1 field G DYNAMICS 2 field (input channels only) For each channel, this shows the name of the type selected for Dynamics 1, the input level, gain reduction amount, and threshold. If GATE is selected as the dynamics type, a three-step indicator shows the presence or absence of a signal, and the open/closed status of the gate. H TO MIX/TO MATRIX field This shows the send level of the signal sent from each channel to the MIX buses / MATRIX buses. (If the senddestinations are MATRIX buses, an indication of "TO MATRIX" is shown at the bottom of the field.) To adjust the send level for each bus, press the corresponding knob to select it, and operate multifunction encoders 1-8. HINT • If input channels are shown, you can use the TO MIX / TO MATRIX button in the SELECTED CHANNEL VIEW screen to change the send-destination shown in this field. • You can also assign the SEND ENCODER MODE function to a user-defined key, and use it to change the send-destination in the same way. If MATRIX channels are selected, the H area will change as follows. K DCA/MUTE GROUP field This shows the DCA group (input channels only) and mute group to which each channel belongs. L Channel number / Channel name field This shows the number, channel name, and icon for the up to eight channels that are currently selected for operation in the Centralogic section (except for the multifunction encoders). Area A shows the channels that can be controlled by the OVERVIEW screen, multifunction encoders, [SEL] keys, and [CUE] keys. Area L shows the channels or DCA groups that can be controlled by the Centralogic section's faders and [ON] keys. For example if you assign DCA groups to the Centralogic section, the OVERVIEW screen will continue showing the eight channels that had been displayed until then, and in this case the channels or DCA groups shown in areas A and L will be different. On the M7CL, you can leave the channels/groups assigned 8 to the Centralogic section fixed, and switch only the eight- channel groups displayed in the OVERVIEW screen (→ p. 104), and the content shown in A and L will differ in this case as well. Operations in the Centralogic section 9 I FROM MIX field This shows the send level of the signals sent from MIX channels 1-16 to each MATRIX bus. To adjust the send level for each bus, press the corresponding knob to select it, and operate multifunction encoders 1-8. J TO STEREO/MONO field This shows the on/off status of the signal sent from each channel to the STEREO bus and MONO bus, and the panning of the signal sent to the STEREO bus (or the left/ right volume balance if the send-source is stereo). To adjust the value, press the knob to select it, and operate multifunction encoders 1-8. M7CL Owner's Manual 99