Yamaha M7CL M7cl V3 Owner's Manual - Page 58
A parametric EQ with four bands; HIGH, HIGH MID, MIX ON/OFF MIX send on/off
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Signal flow for input channels ● INPUT PATCH This assigns an input signal to the input channel. ● ø (Phase) Switches the phase of the input signal. ● HPF (High Pass Filter) This is a high pass filter that cuts the region below the specified frequency. ● ATT (Attenuator) Attenuates/boosts the level of the input signal. ● 4 BAND EQ (4 band equalizer) A parametric EQ with four bands; HIGH, HIGH MID, LOW MID, and LOW. ● DYNAMICS 1 This is a dynamics processor that can be used for gating, ducking, expander, or compressor. ● DYNAMICS 2 This is a dynamics processor that can be used as a compressor, compander, or de-esser. ● LEVEL/DCA 1-8 Adjusts the input level of the channel. ● ON (On/off) Turns the input channel on/off. If off, that channel is muted. ● PAN This adjusts the panning of the signal sent from the INPUT channel to the STEREO bus. If necessary, you can turn on PAN LINK in the BUS SETUP popup window so that the setting of this parameter will also be applied to the signal sent to two MIX or MATRIX buses that are set to stereo. ● BALANCE On ST IN channels, the BALANCE parameter is used instead of PAN. The BALANCE parameter adjusts the volume balance of the left/right signals sent from the ST IN channel to the STEREO bus. If necessary, you can turn on PAN LINK in the BUS SETUP popup window so that the setting of this parameter will also be applied to the signal sent to two MIX or MATRIX buses that are set to stereo. ● LCR (Left/Center/Right) This sends the signal of the input channel as a three-channel output (the MONO (C) channel and the L/R channels) to the STEREO bus / MONO bus. ● MIX ON/OFF (MIX send on/off) This is an on/off switch for the signal sent from the input channel to MIX buses 1-16. ● MIX LEVEL 1-16 (MIX send level 1-16) This adjusts the send level of the signal sent from the input channel to VARI type MIX buses 1-16. As the position from which the signal is sent to the MIX bus, you can choose from the following; immediately before ATT, prefader, or post-fader. ● MATRIX ON/OFF (MATRIX send on/off) This is an on/off switch for the signal sent from the input channel to MATRIX buses 1-8. ● MATRIX LEVEL 1-8 (MATRIX send levels 1-8) Adjusts the send level of the signal sent from the input channel to MATRIX buses 1-8. As the position from which the signal is sent to the MATRIX bus, you can choose from the following; immediately before ATT, prefader, or post-fader. ● INSERT (INPUT channels only) You can patch the desired output/input ports to insert an external device such as an effect processor. For the position of the insert-out/insert-in point, you can choose immediately before ATT, immediately before the fader, or immediately after the [ON] key. ● DIRECT OUT (INPUT channels only) This can be patched to any output port, and the input signal sent directly from that output port. For the position of the direct output, you can choose immediately before HPF, immediately before ATT, immediately before the fader, or immediately after the [ON] key. ● METER This meters the level of the input channel. You can switch the position at which the level is detected. 58 M7CL Owner's Manual