Yamaha M7CL M7cl V3 Owner's Manual - Page 70
Using the faders (SENDS ON FADER mode), Use the TO MIX SEND ON/OFF buttons
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Sending the signal from an input channel to a MIX bus D PRE button This button switches the position at which the signal is sent from the input channel to a VARI type MIX bus. The signal is sent from the post-fader position when this button is off, and from the pre-fader position when this button is on. E TO MIX SEND ON/OFF button These are on/off switches for the signal sent from the input channels to the MIX bus. F TO MIX SEND LEVEL knob This screen shows the send level of the signal sent from the input channels to the MIX bus. To adjust the level, operate multifunction encoders 1-8. If the send-destination MIX bus is set to stereo, the TO MIX PAN knob (for a ST IN channel, the TO MIX BALANCE knob) and TO MIX SEND LEVEL knob are shown in this location. G ALL PRE button This button selects PRE as the position from which signals are sent from all input channels to VARI-type MIX buses. H ALL POST button This button selects POST as the position from which signals are sent from all input channels to VARI-type MIX buses. 6 Use the TO MIX SEND ON/OFF buttons to switch the signals sent from the input channels to the currently selected MIX bus on/ off. 7 If necessary, use the PRE buttons to select the location of the signal that is sent from each input channel to a VARI type MIX bus. HINT • If the PRE button is on, you can also select PRE EQ (immediately before the attenuator) or PRE FADER (immediately before the fader) for each MIX bus. This setting is made in the BUS SETUP popup window (→ p. 234). • The PRE button is not shown for FIXED type MIX buses. 8 Repeat steps 3-6 to adjust the send level for other MIX buses in the same way. Using the faders (SENDS ON FADER mode) Here's how you can use the faders of the top panel to adjust the signal that is sent from all input channels to a specific MIX bus. 1 Make sure that an output port is assigned to each MIX bus to which you want to send signals, and that your monitor system or external effect etc. is connected to the corresponding output port. For details on assigning an output port to a MIX bus refer to p. 105. For details on connecting an external device, refer to p. 46. 2 In the function access area, press the SENDS ON FADER button. The M7CL will switch to SENDS ON FADER mode. The most recently selected group of MIX or MATRIX buses will be assigned to the Centralogic section. The faders of the INPUT section and ST IN section will move to the send level values of each channel for the currently selected MIX or MATRIX bus. In SENDS ON FADER mode, the function access area in the display will show the button that enable you to switch between MIX ON FADER mode and MATRIX ON FADER mode, and the buttons that enable you to select the destination MIX/MATRIX buses. 1 2 1 MIX/MTRX ON FADER switch button Pressing this button repeatedly will toggle between MIX ON FADER mode and MATRIX ON FADER mode. B MIX/MATRIX bus selection buttons These buttons enable you to select the destination MIX/MATRIX buses. Only one button will appear if two buses are paired as stereo. 3 Press the MIX/MTRX ON FADER switch button to select MIX ON FADER mode. In this way, you can use the MIX/MATRIX bus selection buttons to specify the destination MIX buses. 70 M7CL Owner's Manual