Yamaha M7CL M7cl V3 Owner's Manual - Page 75
Using the faders (SENDS ON FADER mode), Use the TO MATRIX SEND ON/OFF buttons
![]() |
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Sending the signal from an input channel to the MATRIX buses D PRE button This button selects the location from which the signal of the input channel will be sent to the MATRIX bus. The signal will be sent from POST (Immediately after the [ON] key) if this button is off. The signal will be sent from the PRE EQ (Immediately before the attenuator) or PRE FADER (Immediately before the fader) as specified in the BUS SETUP popup window if this button is on. E TO MATRIX SEND ON/OFF button These are on/off switches for the signal sent from the input channels to the MATRIX bus. F TO MATRIX SEND LEVEL knob This screen shows the send level of the signal sent from the input channels to the MATRIX bus. To adjust the level, operate multifunction encoders 1-8. If the send-destination MATRIX bus is set to stereo, the TO MATRIX PAN knob (for a ST IN channel, the TO MATRIX BALANCE knob) and TO MATRIX SEND LEVEL knob are shown in this location. G ALL PRE button This button selects PRE as the position from which signals are sent from all input channels to MATRIX buses. H ALL POST button This button selects POST as the position from which signals are sent from all input channels to MATRIX buses. 6 Use the TO MATRIX SEND ON/OFF buttons to switch the signals sent from the input channels to the currently selected MATRIX bus on/off. 7 If necessary, use the PRE buttons to select the location of the signal that is sent from each input channel to a MATRIX bus. 8 Repeat steps 3-6 to adjust the send level for other MATRIX buses in the same way. Using the faders (SENDS ON FADER mode) Here's how you can use the faders on the top panel to adjust the signal that is sent from all input channels to a specific MATRIX bus. 1 Make sure that an output port is assigned to each MATRIX bus to which you want to send signals, and that your monitor system or external effect etc. is connected to the corresponding output port. For details on assigning an output port to a MATRIX 5 bus refer to p. 105. For details on connecting an exter- nal device, refer to p. 46. Input channel operations 2 In the function access area, press the SENDS ON FADER button. The M7CL will switch to SENDS ON FADER mode. The most recently selected group of MIX/MATRIX buses will be assigned to the Centralogic section. The faders in the INPUT section and ST IN section will move to reflect the send level of the signals that are routed from each channel to the currently-selected MIX/MATRIX buses. In SENDS ON FADER mode, the function access area in the display will show the button that enable you to switch between MIX ON FADER mode and MATRIX ON FADER mode, and the buttons that enable you to select the destination MIX/MATRIX buses. 1 2 1 MIX/MTRX ON FADER switch button Pressing this button repeatedly will toggle between MIX ON FADER mode and MATRIX ON FADER mode. B MIX/MATRIX bus selection buttons These buttons enable you to select the destination MIX/MATRIX buses. Only one button will appear if two buses are paired as stereo. 3 Press the MIX/MTRX ON FADER switch button to select MATRIX ON FADER mode. In this way, you can use the MIX/MATRIX bus selection buttons to specify the destination MATRIX buses. M7CL Owner's Manual 75
![](/manual_guide/products/yamaha-m7cl-m7cl-v3-owners-manual-9670c06/75.png)