Yamaha M7CL M7cl V3 Owner's Manual - Page 65
Channels for which ST/MONO mode is, selected, In the TO STEREO/MONO popup window
![]() |
View all Yamaha M7CL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Sending the signal from an input channel to the STEREO/MONO buses 7 In the INPUT section or ST IN section of the top panel, make sure that the [ON] key is turned on for the input channel you want to control, and raise the fader to an appropriate position. The subsequent steps will differ depending on whether ST/MONO mode or LCR mode was selected for the channel in step 5. ● Channels for which ST/MONO mode is selected 8 In the TO STEREO/MONO popup window, use the STEREO/MONO button to turn the signal sent from the input channel to the STEREO bus / MONO bus on or off. For a channel that is set to ST/MONO mode, the signals sent to the STEREO bus and to the MONO bus can be switched on/off individually. 9 In the TO STEREO/MONO popup window, use the TO ST PAN knob to set the panning of the signal sent from the input channel to the STEREO bus. ● Channels for which LCR mode is selected 8 In the TO STEREO/MONO popup window, use the LCR button to turn the signals sent from the input channel to the STEREO bus / MONO bus on or off together. For a channel that is set to LCR mode, the signals sent to the STEREO bus and to the MONO bus are switched on/off together. 9 In the TO STEREO/MONO popup window, use the CSR knob to adjust the level difference between the signals sent from that channel to the STEREO (L/R) bus and to the MONO (C) bus. 10 In the TO STEREO/MONO popup window, use the TO ST PAN knob to set the panning of the signal sent from the input channel to the STEREO bus and MONO (C) bus. Signal level Signal level Signal level Signal level If the CSR knob is set to 0%, operating the TO ST PAN knob of an INPUT channel will change the level of the signals sent to the STEREO (L/R) bus and MONO (C) bus as shown in the following diagram. In this case, the TO ST PAN knob operates as a conventional PAN knob, and no signal is sent to the MONO (C) bus. Signal sent to the STEREO (L) bus Signal sent to the STEREO (R) bus 5 Input channel operations L C R TO ST PAN knob Operating the TO ST BALANCE knob of a ST IN channel will change the level of the signals sent from the ST IN L/R channels to the STEREO (L/R) bus and MONO (C) bus as shown in the following diagram. In this case, the TO ST PAN knob operates as a conventional BALANCE knob, and no signal is sent to the MONO (C) bus. Signal sent from the ST IN (L) channel to the STEREO (L) bus L C R TO ST BALANCE knob Signal sent from the ST IN (R) channel to the STEREO (R) bus L C R TO ST BALANCE knob If the CSR knob is set to 100%, operating the INPUT TO ST PAN knob will change the level of the signals sent to the STEREO (L/R) bus and MONO (C) bus as shown in the following diagram. Signal sent to the MONO (C) bus Signal sent to the STEREO (L) bus Signal sent to the STEREO (R) bus L C R PAN knob M7CL Owner's Manual 65
![](/manual_guide/products/yamaha-m7cl-m7cl-v3-owners-manual-9670c06/65.png)