D-Link DWS-3160-24TC DWS-3160 Series Web UI Reference Guide - Page 274

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide this window. Properly configured settings will be displayed in the DHCP Relay Interface Table at the bottom of the window, once the user clicks the Apply button. The user may add up to four server IPs per IP interface on the Switch. Entries may be deleted by clicking the corresponding Delete button. To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Interface Settings as shown below: Figure 12-4 DHCP Relay Interface Settings window The fields that can be configured are described below: Parameter Description Interface Name The IP interface on the Switch that will be connected directly to the Server. Server IP Address Enter the IP address of the DHCP server. Up to four server IPs can be configured per IP Interface. Click the Apply button to accept the changes made. DHCP Relay Option 60 Server Settings This window is used to configure the DHCP relay option 60 server parameters. To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Server Settings as shown below: Figure 12-5 DHCP Relay Option 60 Server Settings window The fields that can be configured are described below: Parameter Description Server IP Address Enter the DHCP Relay Option 60 Server Relay IP Address. Mode Use the drop-down menu to select the DHCP Relay Option 60 Server mode. Click the Add button to add a new entry based on the information entered. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. Click the Delete All button to remove all the entries listed. NOTE: When there is no matching server found for the packet based on option 60, the relay servers will be determined by the default relay server setting. DHCP Relay Option 60 Settings 269