D-Link DWS-3160-24TC DWS-3160 Series Web UI Reference Guide - Page 351

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide Software Version Code Download Status Configuration Status Vendor ID Part Number Hardware Type Managing Switch Switch MAC Address Switch IP Address Profile Discovery Reason is enabled), but it is not configured. • Managed - The AP profile configuration has been applied to the AP and it's operating in managed mode. • Failed - The Unified Switch lost contact with the AP, a failed entry will remain in the managed AP database unless you remove it. Note that a managed AP will temporarily show a failed status during a reset. NOTE: When management connectivity is lost for a managed AP, then both radios of the AP are turned down. All the clients associated with the AP get disassociated. The radios become operational if and when that AP is managed again by a switch. Display the version of software on the AP. This is learned from the AP during discovery. The current status of a code download request for this AP. The possible values are: • Not Started - No download has begun. • Requested - A download is planned for this AP, but the AP is not in the current download group, so it hasn't been told to start the download yet. • Code-Transfer-In-Progress - The AP has been told to download the code. • Failure - The AP reported a failing code download. • Aborted - The download was aborted before the AP loaded code from the TFTP server. • Waiting-For-APs-To-Download - A download finished on this AP, and it is waiting for other APs to finish download. Reset command is not sent to the AP in this state. • NVRAM-Update-In-Progress - Download completed successfully. The reset command sent to the AP. • Timed-Out - The AP did not reconnect to the Unified Switch in the fixed time interval. Display whether the AP is configured successfully with the assigned profile. The status is one of the following: • Not Configured - The profile has not been sent to the AP yet, the AP may be discovered but not yet authenticated. • In Progress - The switch is currently sending the AP profile configuration packet to the AP. • Success - The entire profile has been sent to the AP and there were no configuration errors. • Partial Success - The entire profile has been sent to the AP and there were configuration errors, but the AP is operational. • Failure - The profile has been sent to the AP and there were configuration errors, the AP is not operational. Vendor of the AP software, this is learned from the AP during discovery. Hardware part number for the AP, which is learned from the AP during discovery. Hardware platform for the AP, which is learned from the AP during discovery. Display whether the AP is managed by the local switch or a peer switch. The MAC address of the switch that is managing the AP. The IP address of the switch that is managing the AP. The AP profile configuration currently applied to the managed AP, the profile is assigned to the AP in the valid AP database. NOTE: Once an AP is discovered and managed by the Unified Switch, if the profile is changed in the valid AP database (either locally or on the RADIUS server) the AP must be reset to configure with the new profile. This status value indicates how the managed AP was discovered, the status is one of the following values: 346