D-Link DWS-3160-24TC DWS-3160 Series Web UI Reference Guide - Page 313

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide Analyzer Server ID (1- The analyzer server ID specifies the ID of a server analyzer where the packet will be 4) forwarded. Interval (20-120) The maximum number of seconds between successive samples of the counters. Tick the Disabled check box to disable the polling interval. Click the Apply button to accept the changes made. Click the Delete All button to remove all the entries listed. Click the Edit button to re-configure the specific entry. Click the Delete button to remove the specific entry. Ping Test Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the network. To view this window, click Monitoring > Ping Test as shown below: Figure 14-23 Ping Test window The user may click the Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to keep sending ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to choose a specific number of times to ping the Target IP Address by clicking its radio button and entering a number between 1 and 255. The fields that can be configured are described below: Parameter Description Target IPv4 Address Target IPv6 Address (EI Mode Only) Repeat Pinging for Size (EI Mode Only) Timeout Enter an IP address to be pinged. Enter an IPv6 address to be pinged. Enter the number of times desired to attempt to Ping either the IPv4 address or the IPv6 address configured in this window. Users may enter a number of times between 1 and 255. For IPv6 only, enter a value between 1 and 6000. The default is 100. Select a timeout period between 1 and 99 seconds for this Ping message to reach its 308