D-Link DWS-3160-24TC DWS-3160 Series Web UI Reference Guide - Page 32

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide To view the following window, click Management > IP Interface > System IP Address Settings, as show below: Figure 6-7 System IP Address Settings window The fields that can be configured are described below: Parameter Description Static DHCP BOOTP Allow the entry of an IP address, subnet mask, and a default gateway for the Switch. These fields should be of the form xxx.xxx.xxx.xxx, where each xxx is a number (represented in decimal form) between 0 and 255. This address should be a unique address on the network assigned for use by the network administrator. The Switch will send out a DHCP broadcast request when it is powered up. The DHCP protocol allows IP addresses, network masks, and default gateways to be assigned by a DHCP server. If this option is set, the Switch will first look for a DHCP server to provide it with this information before using the default or previously entered settings. The Switch will send out a BOOTP broadcast request when it is powered up. The BOOTP protocol allows IP addresses, network masks, and default gateways to be assigned by a central BOOTP server. If this option is set, the Switch will first look for a BOOTP server to provide it with this information before using the default or previously entered settings. The following table will describe the fields that are about the System Interface. Parameter Description Interface Name Management VLAN Name Interface Admin State IP Address Subnet Mask Gateway Display the System interface name. This allows the entry of a VLAN name from which a management station will be allowed to manage the Switch using TCP/IP (in-band via Web manager or Telnet). Management stations that are on VLANs other than the one entered here will not be able to manage the Switch in-band unless their IP addresses are entered in the Trusted Host window (Security > Trusted Host). If VLANs have not yet been configured for the Switch, the default VLAN contains all of the Switch's ports. There are no entries in the Trusted Host table, by default, so any management station that can connect to the Switch can access the Switch until a management VLAN is specified or Management Station IP addresses are assigned. Use the drop-down menu to enable or disable the configuration on this interface. If the state is disabled, the IP interface cannot be accessed. This field allows the entry of an IPv4 address to be assigned to this IP interface. A Bitmask that determines the extent of the subnet that the Switch is on. Should be of the form xxx.xxx.xxx.xxx, where each xxx is a number (represented in decimal) between 0 and 255. The value should be 255.0.0.0 for a Class A network, 255.255.0.0 for a Class B network, and 255.255.255.0 for a Class C network, but custom subnet masks are allowed. IP address that determines where packets with a destination address outside the 27