D-Link DWS-3160-24TC DWS-3160 Series Web UI Reference Guide - Page 366

DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide Physical Mode Security Mode 802.11n Mode Beacon Interval Highest Supported Rate Peer Managed AP Ad hoc Network OUI Description Display the 802.11 mode being used on the AP. Security mode used by the AP. Display whether this AP supports IEEE 802.11n mode. Beacon interval for the neighbor AP network. Highest supported rate advertised by this AP in the beacon frames. The rate is represented in increments of 1 Mbps. Display whether this AP is managed by a switch in the cluster. Display whether the beacon frame was received from an ad hoc network. Display the manufacturer of the AP or wireless client adapter based on the information in the OUI database on the switch. After clicking the AP Triangulation Status tab, the following page will appear: Figure 2-31 AP RF Scan Status - AP Triangulation Status window The fields that can be displayed are described below: Parameter Description Detected AP MAC Address Sentry MAC Address Radio RSSI(%) Signal Strength(dBm) Noise Level(dBm) Age The Ethernet MAC address of the detected AP. This could be a physical radio interface or VAP MAC. For D-Link APs this is always a VAP MAC address. Display whether the AP that detected the entry is in sentry or non-sentry mode. Display the MAC address of the AP that detected the RF Scan entry. The address links to the Valid AP database. Display the radio on the AP that detected the RF Scan entry. Display the received signal strength indicator in terms of percentage for the nonsentry AP. The range is from 0 to 100%. A value of 0 indicates the AP is not detected. Received signal strength for the non-sentry AP. The range is from -127 dBm to 127 dBm, but most values are expected to range from -95 dBm to -10 dBm. Noise reported on the channel by the non-sentry AP. Time since this AP was last detected in an RF scan. 361