Kyocera FS-C8500DN FS-C8500DN Operation Guide - Page 46

Thickness The paper used with the machine should be neither extremely thick nor extremely thin. If you are having problems with paper jams, multiple feeds, and faint printing, the paper you are using may be too thin. If you are having problems with paper jams and blurred printing the paper may be too thick. The correct thickness is 0.086 to 0.110 mm (3.4 to 4.3 mils). Moisture Content Moisture content is defined as the percent ratio of moisture to the dry mass of the paper. Moisture can affect the paper's appearance, feed ability, curl, electrostatic properties, and toner fusing characteristics. The moisture content of the paper varies with the relative humidity in the room. When the relative humidity is high and the paper absorbs moisture, the paper edges expand, becoming wavy in appearance. When the relative humidity is low and the paper loses moisture, the edges shrink and tighten, and print contrast may suffer. Wavy or tight edges can cause jams and alignment anomalies. The moisture content of the paper should be 4 to 6 %. To ensure correct moisture content, it is important to store the paper in a controlled environment. Some tips on moisture control are: • Store paper in a cool, dry location. • Keep the paper in its wrapping as long as possible. Re-wrap paper that is not in use. • Store paper in its original carton. Place a pallet etc. under the carton to separate it from the floor. • After removing paper from storage, let it stand in the same room as the machine for 48 hours before use. • Avoid leaving paper where it is exposed to heat, sunlight, or damp. Note When using coated paper, be aware that the sheets will stick together in a very humid environment. Paper Grain When paper is manufactured, it is cut into sheets with the grain running parallel to the length (long grain) or parallel to the width (short grain). Short grain paper can cause feeding problems in the machine. All paper used in the machine should be long grain. Other Paper Properties Porosity: Indicates the density of paper fiber. Stiffness: Limp paper may buckle in the machine, resulting in paper jams. Curl: Most paper naturally tends to curl one way if left unpacked. Electrostatic discharge: During the printing process the paper is electrostatically charged to attract the toner. The paper must be able to release this charge so that printed sheets do not cling together in the Output Tray. 3-6 Handling Paper