Kyocera TASKalfa 181 Fax System (R) Operation Guide - Page 67

3 Various Functions of this Fax Sending 2-Sided Documents (Duplex Transmission) Duplex Transmission enables the transmission of both the front and back sides of duplex (2-sided) documents when the optional Document Processor is installed. Duplex transmission is always accomplished by setting the documents you want to transmit in the Document Processor and scanning them into memory in the Memory Transmission mode. It is also possible to use Duplex Transmission capabilities in combination with each of the other various types of fax communication available in this fax. The following method explains the procedure for sending duplex documents to a single destination. Notes • To enable Duplex Transmission, you must select Standard size original when setting the document size for scanning from the Document Feeder. Duplex Transmission will not be available if the document size is set to Long original. (See Setting the Document Size for Scanning from the Document Processor ("Scan from DP" setting) on page 7-10.) • If you press the Duplex TX key during any operation, Dial Confirmation for one-touch keys will not be available. It will also be necessary to press the Start key in order to initiate dialing for abbreviated numbers and one-touch keys. • In order to schedule a start time for the transmission, press the Delayed TX key at any point in the procedure PRIOR to entering the destination fax number. • If you want to cancel the procedure part way through, press the Reset key. The operation panel will return to the initial mode settings. 1 Set the 2-sided documents in the Document Processor. 2 Open the cover plate to the left and press the Duplex TX key. The letter D will be displayed in the first line of the message display to indicate this is a duplex transmission. You can cancel a Duplex Transmission by simply pressing the Duplex TX key again. 3-1