Kyocera TASKalfa 181 Fax System (R) Operation Guide - Page 73

Various Functions of this Fax Sending Important Documents Before Others (Interrupt Transmission) Interrupt Transmission lets you send your documents before others, eliminating the need to wait until all communications are complete whenever the fax is currently scheduled for multiple communications (Broadcast Transmission or Polling Reception, etc.), or there are other communications already scheduled in memory ahead of yours. Notes 1 • Interrupt Transmission may only be accomplished to a single destination. • You can schedule up to 50 Interrupt Transmissions (including communications that use the timer and Interrupt Transmissions) at one time. • Depending on the timing of when you perform the Interrupt Transmission procedure, there are occasions where your documents may not be sent immediately after the current communication. • If you want to cancel an Interrupt Transmission, simply remove the documents from the Document Processor or the platen. • If you press the Stop/Clear key while an Interrupt Transmission is waiting to start, perform the same procedure as in < If you press the Stop/Clear key during a Standby Transmission in the Direct Feed Transmission mode... > on page 3-4. Open the cover plate to the right and press the Memory TX key. Make sure the Memory TX indicator is lit (the fax is in the Direct Feed Transmission mode). 2 Set the documents you want to transmit in the Document Processor or on the platen. 3 Enter the destination fax number. :0 Document : Press START key. 4 Press the Start key. The documents will remain in the Document Processor or on the platen, without being scanned, waiting for the transmitting operation to begin. Once the operation currently in progress is completed, the transmission operation for your documents will begin automatically. 3-7