Canon EOS C70 Instruction Manual - Page 145
In the [Select a network] screen, select [Camera Access Point Mode]., Camera Access Point
View all Canon EOS C70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Configuring Connection Settings Camera Access Point Connect a network device with the camera's access point. Two configuration methods are available: easy connection and manual connection. 1 In the [Select a network] screen, select [Camera Access Point Mode]. 2 Select the configuration method. • Depending on the selected method, perform either step 3 or steps 3-7 and then continue to step 8. 145 [Easy Connection] 3 The camera will assign the network name (SSID) and password automatically. Review the settings for the camera's Wi-Fi access point and select [OK]. • These settings are necessary to connect a network device to the camera. [Manual Connection] 3 Enter the SSID (network name) for the Camera Access Point and then select [OK]. • Enter the desired network name using the keyboard screen (A 25). 4 Select the Wi-Fi channel. • Select [Automatic Setting] to have the camera select the channel automatically, or select [Manual Setting] > Desired channel. 5 Select the encryption settings. • Select [AES] to use AES encryption, or [Disable] to use no encryption. • If you selected [Disable], skip to step 7. 6 Enter the password for the Camera Access Point and then select [OK]. • Enter the desired password using the keyboard screen (A 25). 7 Set the IP address (A 147). Both configuration methods 8 Select [OK] to continue to configure the function settings. • The communication settings are saved to an [NW] file. • Continue with one the following procedures to configure the selected function's settings. FTP transfer (A 141), Browser Remote (A 144) 9 Before you can save the connection setting, connect the network device to the camera. • Activate the device's Wi-Fi function, select the camera's SSID (network name) from the list and enter the password to connect to the camera. WPS using a PIN Code Connect to an access point using a PIN code. For most wireless routers, you must use a Web browser to access the setup screen. For details on how to set up the access point, refer to the access point's user manual. 1 In the [Select a network] screen, select [Connect with WPS] > [WPS (PIN Code)]. • The camera will generate and display an 8-digit PIN code. 2 Enter the PIN code into the wireless router's WPS (PIN code) setup screen and then, on the camera, select [OK]. 3 Set the IP address (A 147). 4 Select [OK] to continue to configure the function settings. • The communication settings are saved to an [NW] file. • Continue with one the following procedures to configure the selected function's settings. FTP transfer (A 141), IP streaming (A 143), Browser Remote (A 144)