Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1061

Example This example globally configures the format of the MAC address sent in the Calling-Station-Id attribute to IETF lower case. It also configures interface Gi1/0/1 to use MAB. For this command to have any affect, MAB must be configured on the switch in an active authentication list, IEEE 802.1X must be configured, and a RADIUS server must also be configured. console(config)#radius server attribute 31 mac format ietf lower-case console(config)#interface gi1/0/1 console(config-if-Gi1/0/1)#authentication host-mode multi-auth console(config-if-Gi1/0/1)#mab radius server attribute 168 Use the radius server attribute 168 include-in-access-req command to enable the switch to send the RADIUS Framed-IPv6-Address attribute in AccessRequest messages sent to the RADIUS authentication server. Syntax radius server attribute 168 include-in-access-req no radius server attribute 168 include-in-access-req Default Configuration By default, RADIUS attribute 168 is not sent. Command Mode Global Configuration mode. User Guidelines The switch sends the IPv6 address of the host attempting to access the network in the Framed-IPv6-Address attribute if it is available to the switch. If accounting is enabled and the address is available to the switch, the switch will send the IPv6 address in the Access-Request, Acct-Start/AcctInterim/Acct-Stop messages sent to the accounting server. The switch discovers the client IPv6 address via its inclusion in the RADIUS Access-Accept, or via DHCPv6 snooping. DHCPv6 snooping must be enabled for the switch to discover a host IPv6 address. Security Commands 1061