Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1292

User Guidelines A route reflector and its clients form a cluster. Since a cluster with a single route reflector has a single point of failure, a cluster may be configured with multiple route reflectors. To avoid sending multiple copies of a route to a client, each route reflector in a cluster should be configured with the same cluster ID. Route reflectors with the same cluster ID must have the same set of clients; otherwise, some routes may not be reflected to some clients. The same cluster ID is used for both IPv4 and IPv6 route reflection. Command History Introduced in version 6.2.0.1 firmware. Example console(config-router)#bgp cluster-id 1 bgp default local-preference Use the bgp default local-preference command to enable the network operator to specify the default local preference. Local preference is an attribute sent to internal peers to indicate the degree of preference for a route. A route with a numerically higher local value is preferred over a route with a numerically lower value. Syntax bgp default local-preference number no bgp default local-preference • number-The value to use as the local preference for routes advertised to internal peers. The range is 0 to 4,294,967,295. Default Configuration If no other value is configured, BGP advertises a local preference of 100 in UPDATE messages to internal peers. Command Mode BGP Router Configuration mode Layer 3 Routing Commands 1292