Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 792

service-policy Use the service-policy command in either Global Configuration mode (for all system interfaces) or Interface Configuration mode (for a specific interface) to attach a policy to an interface. To return to the system default, use the no form of this command. NOTE: This command is not available on the N1500 Series switches. Syntax service-policy {in|out} policymapname no service-policy {in|out} policymapname • policymapname-Specifies the DiffServ policy name as a unique case- sensitive alphanumeric string. (Range: 1-31 alphanumeric characters.) • in-Apply the policy on ingress. • out-Apply the policy on egress. Default Configuration No policies are applied by default. Command Mode Global Configuration mode (for all system interfaces) Interface Configuration (Ethernet, Port-channel) mode (for a specific interface) User Guidelines This command applies a DiffServ policy to an interface and enables DiffServ on the interface. No separate interface administrative mode command for DiffServ is available. Use the policy-map command to configure the DiffServ policy. The service-policy direction must match the direction given for the policy map. DiffServ is enabled globally by default. Ensure that no attributes within the policy definition exceed the capabilities of the interface. When a policy is attached to an interface successfully, any attempt to change the policy definition, such that it would result in a violation of the interface capabilities, causes the policy change attempt to Layer 2 Switching Commands 792