Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1374

is configured for BGP (default metric command), the MED is set to the default metric. If both a default metric and a metric value are not configured, the prefix is advertised without an MED attribute. • match-(Optional) By default, if BGP is configured to redistribute OSPF routes, BGP only redistributes internal routes (OSPF intra-area and interarea routes). Use of the match option configures BGP to also redistribute specific types of external routes, or to disable redistribution of internal OSPF routes. The match option is only valid for OSPF originated routes. • route-map map-tag-(Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix list. Default Configuration BGP redistributes no routes by default. When BGP redistributes OSPF routes, it redistributes only internal routes unless the match option specifies external routes. Command Mode BGP Router Configuration mode User Guidelines The distribute-list out command can also be used to filter redistributed routes by prefix. Either a redistribute route map or a distribute list may be configured, but not both. Successive invocations of the redistribute command are additive. The redistribute command does not overwrite previous redistribute command configuration or the default configuration. Use the no redistribute command to remove the redistribution of internal or external routes. A default route cannot be redistributed unless the default-informationoriginate command is given. The configured metric value is specific to the routes distributed. Use the default-metric command to configure a default metric for all redistributed routes. Layer 3 Routing Commands 1374