Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 284

ip access-list Use the ip access-list command in Global Configuration mode to create an Access Control List (ACL) that is identified by the parameter list-name and to enter IPv4-Access-List configuration mode. If parameterized with the name of an existing access list, additional match clauses are added to the end of the access list. Syntax ip access-list list-name [extended] no ip access-list list-name • list-name-Access-list name up to 31 characters in length. Default Configuration This command has no default configuration. Command Mode Global Configuration mode User Guidelines Access lists use the extended access list format. Multiple permit and deny clauses and actions may be specified without requiring the access list name to be entered each time. Permit and deny clauses are entered in order from the first match clause when in Access List Configuration mode. ACL names are global. An IPv6 access list cannot have the same name as an IPv4 access list. Access list names can consist of any printable character except a question mark. Names can be up to 31 characters in length. ACLs referenced in a route map may not be edited. Instead, create a new ACL with the desired changes and refer to the new ACL in the route map. deny | permit (IP ACL) Use this command in Ipv4-Access-List Configuration mode to create a new rule for the current IP access list. Each rule is appended to the list of configured rules for the list if no sequence number is specified. Use the no form of the command to delete an existing permit/deny clause. Layer 2 Switching Commands 284