Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1586

Example The following example clears IPv6 statistics for VLAN 11. console(config)#clear ipv6 statistics vlan 11 ipv6 address Use the ipv6 address command in Interface Configuration mode to configure an IPv6 address on an interface (including VLAN, tunnel and loopback interfaces) and to enable IPv6 processing on this interface. Multiple globally reachable addresses can be assigned to an interface by using this command. There is no need to assign a link-local address by using this command since one is automatically created. IPv6 addresses can be expressed in eight blocks. Also of note is that instead of a period, a colon separates each block. For simplification, leading zeros of each 16-bit block can be omitted. One sequence of 16-bit blocks containing only zeros can be replaced with a double colon "::", but not more than one at a time (otherwise it is no longer a unique representation). Dropping zeros: 3ffe:ffff:100:f101:0:0:0:1 becomes 3ffe:ffff:100:f101::1 Local host: 0000:0000:0000:0000:0000:0000:0000:0001 becomes ::1 Any host: 0000:0000:0000:0000:0000:0000:0000:0000 becomes :: The hexadecimal letters in the IPv6 addresses are not case-sensitive. An example of an IPv6 prefix and prefix length is 3ffe:1::1234/64. Syntax ipv6 address prefix/prefix-length [link-local] [eui64] no ipv6 address [prefix/prefix-length] [link-local] [eui64] • prefix - Consists of the bits of the address to be configured. • prefix-length - Designates how many of the high-order contiguous bits of the address make up the prefix. • link-local - Manually configure a link-local address on an interface. • eui64 - The optional eui-64 field designates that IPv6 processing on the interfaces is enabled using an EUI-64 interface ID in the low order 64 bits of the address. If this option is used, the value of prefix_length must be 64 bits. On Dell EMC Networking switches, all Layer 3 interfaces share the same MAC address. Layer 3 Routing Commands 1586