Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2412

Command Mode Privileged Exec mode User Guidelines Traceroute operates by sending a sequence of Internet Control Message Protocol (ICMP) echo request packets. The time-to-live (TTL) value, is used in determining the intermediate routers through which the packet flows toward the destination address. Routers decrement a packet's TTL value and discard packets whose TTL equals 0. On discarding a packet, the router returns an ICMP time exceeded message to the source. Loopback interfaces are not supported on the N1100-ON Series switches. The hostname parameter may be a fully or partially qualified domain name. A hostname consists of a series of labels separated by periods. Each label may be a maximum of 63 characters in length. The maximum length of the hostname parameter is 256 characters. Refer to RFC 1035 Section 2.3.1 for more information. Examples The following example discovers the routes that packets will actually take when traveling to the destination specified in the command. (console)# traceroute ipv6 2001::2 init-ttl 1 max-ttl 4 max-fail 0 interval 1 count 3 port 33434 size 43 Traceroute to 2001::2, 4 hops max, 43 byte packets: 1 2001::2 708 msec 41 msec 11 msec 2 2001::2 12 msec 13 msec 12 msec 3 2001::2 14 msec 9 msec 11 msec Command History Syntax and description updated in 6.4 release. update bootcode Use the update bootcode command to update the bootcode on one or more switches. For each switch, the bootcode is extracted from the active image and programmed to flash. Switch Management Commands 2412