Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 883

Command Mode Interface Configuration (Ethernet) mode User Guidelines This command has no user guidelines. Example The following example displays how to add an Ethernet interface to the group ID of "2." console(config-if-Gi1/0/1)#protocol vlan group 2 protocol vlan group all Use the protocol vlan group all command in Global Configuration mode to add all physical interfaces to the protocol-based group identified by groupid. A group may have more than one interface associated with it. Each interface and protocol combination can be associated with one group only. If adding an interface to a group causes any conflicts with protocols currently associated with the group, this command fails and the interface(s) are not added to the group. Ensure that the referenced VLAN is created prior to the creation of the protocol-based group except when GVRP is expected to create the VLAN. To remove all interfaces from this protocol-based group that is identified by this groupid, use the no form of the command Syntax protocol vlan group all group-id no protocol vlan group all group-id • group-id - The protocol-based VLAN group ID, which is automatically generated when you create a protocol-based VLAN group with the vlan protocol group command. To see the group ID associated with the name of a protocol group, use the show port protocol all command. Default Configuration This command has no default configuration. Layer 2 Switching Commands 883