Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1564

User Guidelines The VRF identified in the parameter must have been previously created or an error is returned. The VRF parameter is only available on the N3000-ON/N3100-ON/N3200ON series switches. The command displays the following information. Parameter BGP Section: Routing Protocol Router ID Local AS Number BGP Admin Mode Maximum Paths Distance Prefix List In Prefix List Out Neighbors OSPFv2 Section Routing Protocol Router ID Description BGP. The router ID configured for BGP. The AS number that the local router is in. Whether BGP is globally enabled or disabled. The maximum number of next hops in an internal or external BGP route. The default administrative distance (or route preference) for external, internal, and locally-originated BGP routes. The table that follows lists ranges of neighbor addresses that have been configured to override the default distance with a neighborspecific distance. If a neighbor's address falls within one of these ranges, routes from that neighbor are assigned the configured distance. If a prefix list is configured, then the distance is only assigned to prefixes from the neighbor that are permitted by the prefix list. The global prefix list used to filter inbound routes from all neighbors. The global prefix list used to filter outbound routes to all neighbors. A list of configured neighbors and the inbound and outbound policies configured for each. OSPFv2. The router ID configured for OSPFv2. Layer 3 Routing Commands 1564