Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1238

Only IPv4 addresses are supported for OpenFlow controllers. OpenFlow operates on the management unit in the stack only. Flows may not be configured on stack members. Failover to the stack standby unit is not supported. OpenFlow should only be enabled on stand-alone switches and should not be enabled on stacks of switches. This restriction is not enforced. Command History Introduced in version 6.3.0.1 firmware. Example This example configures an interface using VLAN 10 with IPv4 address 1.2.3.1, configures a connection to the controller at IPv4 address 1.2.3.4 TCP port 3435 using SSL security and initiates the connection over the switch front panel interface. The local switch is configured with a static IP address after being configured into static address mode. console(config)#vlan 10 console(config-vlan10)#interface vlan 10 console(config-if-vlan10)#ip address 1.2.3.1 255.255.0.0 console(config-if-vlan10)#interface gi1/0/1 console(config-if-Gi1/0/1)#switchport mode access console(config-if-Gi1/0/1)#switchport access vlan 10 console(config)#openflow WARNING! OpenFlow does not operate on stack members. Enable OpenFlow on stand-alone switches only. console(config-of-switch)#controller ipv4 1.2.3.4 port 3435 security ssl console(config-of-switch)#mode static console(config-of-switch)#ipv4 address 1.2.3.1 console(config-of-switch)#exit mode Use the mode command to configure the selection of interfaces used to assign the IP address utilized for controller connections. Use the no form of the command to return the setting to the default. Syntax mode { auto | static | oob } Data Center Technology Commands 1238