Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1611

User Guidelines Enter a track track-number in the ipv6 route command to specify that the static route is installed in the routing table only if the configured SLA tracking object is up. When the track object is down, the route is removed from the Route Table. Only one tracking object can be associated with a static route at a time. Configuring a different tracking object replaces the previously configured tracking object. To display the tracked IPv6 static routes, use the show ipv6 route track-table command. The route created with nexthop belonging to a subnet in another VRF is referred to as a leaked route. The user can create a static leaked route between a default VRF and a non-default VRF, and between non-default VRFs. Command History Command updated in version 6.6 firmware. Syntax to support VRFs added in version 6.7.0 firmware. Example The following example configure an IPv6 static route. console(config)#ipv6 route 2020:1::1/64 2030:1::2 ipv6 route distance Use the ipv6 route distance command in Global Configuration mode to set the default distance (preference) for static routes. Lower route preference values are preferred when determining the best route. The ipv6 route and ipv6 route default commands allow optional setting of the distance of an individual static route. The default distance is used when no distance is specified in these commands. Changing the default distance does not update the distance of existing static routes, even if they were assigned the original default distance. The new default distance is applied to static routes created after invoking the ipv6 route distance command. Syntax ipv6 route distance [vrf vrf-name] integer no ipv6 route distance [vrf vrf-name] integer Layer 3 Routing Commands 1611