Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 1678

• hash-mask-len-The length of a mask that is to be ANDed with the group address before the hash function is called. All groups with the same seed hash correspond to the same RP. For example, if this value is 24, only the first 24 bits of the group addresses matter. This allows you to get one RP for multiple groups. (Range 0-128 bits). • priority-The priority of the candidate BSR. The BSR with the higher priority is preferred. If the priority values are the same, the router with the higher IP address is the BSR. (Range: 0-255). • interval-The interval at which candidate rendezvous point advertisements are sent. Default Configuration The router will not announce its candidacy by default. The default hash mask length is 126 bits. The default priority is 0. The default C-RP advertisement interval is 60 seconds. Command Mode Global Configuration mode User Guidelines There are no user guidelines for this command. Example console(config)#ipv6 pim bsr-candidate vlan 9 10 34 ipv6 pim dense-mode Use the ipv6 pim dense-mode command in Global configuration mode to administratively configure PIM dense mode for IPv6 multicast routing. This command also enables MLD. Use the no form of this command to disable PIM and MLD. This command does not affect ip multicast-routing. Syntax ipv6 pim dense-mode Layer 3 Routing Commands 1678