Dell N3200-ON EMC Networking N-Series Switches CLI Reference Guide version 6.7 - Page 2279

• port - UDP port of the host to use. The default is 162. (Range: 165535.) • filtername - A string that is the name of the filter that define the filter for this host. If unspecified, does not filter anything. (Range: 1-30 characters.) Default Configuration The default configuration is 3 retries and 15 seconds timeout. Command Mode Global Configuration mode User Guidelines The username can include any printable characters except a question mark. Enclose the string in double quotes to include spaces within the key. The surrounding quotes are not used as part of the key. The CLI does not filter illegal characters but may accept entries up to the first illegal character or reject the entry entirely. The hostname parameter may be a fully or partially qualified domain name. A hostname consists of a series of labels separated by periods. Each label may be a maximum of 63 characters in length. The maximum length of the hostname parameter is 256 characters. Refer to RFC 1035 Section 2.3.1 for more information. Example The following example configures an SNMPv3 host, and sets it to send SNMP INFORMS with user name John using authentication without encryption. console(config)# snmp-server v3-host 192.168.0.20 John informs auth The following example shows the syntax of the no snmp-server host ip-address command. console(config)#no snmp-server host 1.2.3.4 ? informs Sends SNMP informs to this host. traps Sends SNMP traps to this host. Command History Example updated in 6.4 release. Switch Management Commands 2279